Torque Batt 18S2P P42A

18S2P TorqueBatt
 
Specs as follows
66.6V Nominal 75.6V charged
8.5AH
P42A Cells
60A continuous Discharge (Note XT60 is rated for 60A however to Pro long the life span of the connector and pack set 50A-55A for battery current in VESC tool) 
Copper/Nickel build method 
copper is by the far the best choice when dealing with high discharge packs
XT60 Discharge XT30 Charge
Wired for ENNOID BMS please contact us with your Preferred BMS options ENNOID/ZBMS/Flipsky Daly etc please note the BMS is not included the photos are  for demonstration purposes only. 
Current leads times are 2-3Weeks from placing the order please contact us if you wish to place an order
6 months Warranty 
Does not cover water damage or miss use of cells ! Over discharge of the pack ie if cells are below 2.5V is not included with warranty.
Please double check your board is shut off and not left on and not stored away with a empty battery this can likely over discharge the battery Pulling it below the safe recovery point which is not covered under warranty. 
Float on